Removes heavy scratches and abrasions from most acrylic surfaces. Use when damage is too severe to be restored with NOVUS No. 2 polish.

• Requires use of NOVUS No. 2 for final finishing
• Not recommended for use on coated plastics

1. Remove surface dirt and dust with NOVUS No. 1.

2. Shake well. Test in an inconspicuous area.

3. Apply NOVUS No. 3 liberally. Using a clean, soft cloth, polish with a firm back-and-forth motion at right angles to the scratches. Keep the cloth saturated with polish at all times.

4. Continue polishing until only fine scratches remain. Using cloth, remove all remaining polish, this is very important!

5. Using a clean cloth, apply NOVUS No. 2 in a circular motion uniformly to entire surface. Polish using light pressure until NOVUS No. 2 dries to a light haze.

6. Using a clean portion of the cloth, buff the surface clean. Follow with NOVUS No. 1 for best results.

Important Points to Remember - Before attempting to clean or remove scratches, always make sure the plastic is cool to the touch. Use a liberal amount of plastic cleaner to safely remove surface dust and dirt. In addition, test scratch removers in a small or inconspicuous area for compatibility. Some plastics are coated with a thin film which may be damaged by the abrasives in the polish. NOVUS No. 2 and No. 3 are not recommended for use on eyeglass lenses.

For the Nearest Distributor Call Toll Free: 1-800-548-6872

NOVUS, Inc.
10425 Hampshire Ave. S.
Minneapolis, Minnesota 55438
Phone: 952-944-8000 Fax: 952-946-0435

©1998 TCG International